Symbology Property Page

Available in all license levels of LP360.

The Symbology Property Page of the LAS Layer Properties (TOC right click menu), Profile Display Properties (Profile Window) (Profile View group on the Map Tab in the ribbon) and 3D and Immersive Viewer Properties (3D Window)  (3D View group on the Map Tab in the ribbon) is used to define the properties (e.g., color and size) for drawing in the applicable views for those legend types not supported in Live View. 

Learn about the Legends
Learn about Layer Transparency
Symbology for Live View

Mono/Hillshade

Define Mono/Hillshade in the view.

Figure 1: Mono/Hillshade Property Page

Monochromatic Color - Opens the Color dialog to pick the monochromatic color for the map display.

Figure 2: Symbology Color Picker

Illumination Properties - Used to adjust properties of hillshade display;

Sun position above the horizon - Angle of the sun in the sky in relation to the Earth's surface. Units are degrees.

Azimuth Position of the sun - Position of the sun in relation to North. Units are degrees.

Learn about the Mono/Hillshade Properties Page

Contours

Determines how contours are displayed in the map view.

General

Define map units and line symbology

Figure 3: Contour Legend Property Page - General

Annotation

Define contour annotation behavior and appearance.

Figure 4: Contour Legend Property Page - Annotation

Learn about the Contour Legend Property Page

Delta Z

Defines display settings when using Display by Elevation Difference display mode.

Figure 5: Delta Z Property Page

Cell Length - Defines size of each display cell

Intervals - Defines the number of ranges used when creating map display, can be set from 3 to 10.

Interval size - Defines the range of each interval.

Figure 6: Display by Delta Z Example

Learn about the Delta Z Property Page

Density

Defines display settings for Display by Point Density display mode.

Figure 7: Density Property Page

Cell Edge Length - Defines size of each display cell

Intervals - Defines the number of ranges used when creating map display, option of 3-10.

Point Density - Sets the uppermost greater than range, the other intervals will be automatically computed based of the entered density.

Units - set units used when determining map display, points per square foot or points per square meter.

Figure 8: Display by Density Example

Learn about the Density Property Page

GIS Fusion

Defines display settings for Display by GIS Fusion display mode.

Figure 9: GIS Fusion Properties Page

Point Symbol - defines the size of all points and the color of points that do not have an RGB value.

Color Source - defines the source of the color values (i.e., RGB Values) to display points.

Learn about the GIS Fusion Legend Property Page