EchoOne & RESEPI Sensors Processing Workflow – LP360

Introduction

In this article, we will explain step by step how to process TELEDYNE EchoONE and/or RESEPI sensors using LP360 Drone. The idea of the article is to serve as a quick user guide on processing. This article will not explain in detail each of the settings available in each step or tool. Those details can be found either in the applicable articles in the Tools & Features section, in the RESEPI Processing article or in the LP360 Drone User Guide.

Prerequisites

Before starting with the workflow, the user will need to have LP360 Drone and a valid PCMasterProGL license installed. The RESEPI processing engine uses PCMasterProGL for trajectory processing and geocoding.

EchoOne & RESEPI Processing Workflow

The processing workflow for the EchoOne and RESEPI sensors follows the same general steps as other supported sensors. Further details are in the LP360 Drone Users Guide and the RESEPI Processing article. These are the recommended steps:

Import Cycle
Create Flight Lines
1. Auto Create Flight Lines
2. Manual Flight Lines
Sensor Processing Launcher
Recommended for batch processing, select RESEPI Processing.
Post Processing
Recommended to split the LAS from RESEPI Processing by flight lines, Photo or LiDAR processing settings.
Strip Align
Control Points & Debias
Smoothing
Ground Classification:
1. Ground Classification Workflow (classic way of classifying a ground surface)
2. AI Ground Classification - Recommended
3D Photo Engine for Orthophoto generation and Colorization refinement.
Alternative, Export Photo Package to export the georeferenced images to be used in a 3rd party photogrammetry software.
Export wizard to export the final LAS, create DEM/DTM and create contour lines.

Related to