SAfE Error when doing Strip Alignment

Software Version:

I've had the SA running overnight and it's always stuck on this:

I can't export a log.

I found these instructions online.

I created the folder on C Drive - C:\StripAlignTempFiles

Then checking %localappdata% no strip align folder was there.

I then ran the %CommonProgramFiles%\LP360\StripAlign\updateSaOpts.bat as an Admin.

No folder or file was created in %localappdata%\stripalign

I then created the stripalign folder manual in %localappdata%

Ran the .bat file again, still no .opt.txt file in the stripalign folder in local app data.

So then I went to %CommonProgramFiles%\LP360\StripAlign and edited the .opt.txt file in there to the following.

Now, when trying the SA again in LP360. It's still stuck on this.

Comments